Victron charge controler - BlueSolar PWM-LCD&USB 12/24V

Victron charge controler - BlueSolar PWM-LCD&USB 12/24V

Features
- Three stage battery charging [bulk – absorption – float]
- Battery type: Lead-acid and LiFePO4 (with internal BMS)
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
- Low voltage load disconnect.
- Temperature protection

Liquid crystal display
For status monitoring and set-up

Load output
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.

Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.

Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)

Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A

More information:

• Victron BlueSolar PWM Charge Controller-LCD&USB 12/24V& 48V. Datasheet.
• Victron BlueSolar PWM Charge Controller-LCD-USB 12/24V, 5/10/20A. Manual.
• Victron BlueSolar PWM Charge Controller-LCD-USB 12/24V/30A, 48V, 10/20/30A. Manual.